Lincoln Aviator: Four-Wheel Drive Systems / General Procedures - Transfer Case Clutch Learn
Activation
-
Update the AWD (all-wheel drive) module to the
latest calibration available. Module reprogramming will erase stored
transfer case clutch kiss point values and initiate rapid kiss point
learn procedure. If no later calibration is available then proceed with
process below:
-
2. Open driver’s side door.
-
3. Close driver’s side door.
-
7. Repeat steps 1-6 thirty five (35) times.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
Vehicle/Axle Stands
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service expense...
Special Tool(s) /
General Equipment
412-001
(T71P-19703-B)
Remover, Compressor Pulley
Activation
Remove the A/C compressor. Refer to Air Conditioning A/C Compressor procedure in Group 412.
NOTE:
If equipped with spring rubber clutch...
Categories
The front outboard and rear safety restraints
in the vehicle are combination lap and
shoulder belts.
Insert the belt tongue into the proper
buckle (the buckle closest to the direction
the tongue is coming from) until you hear
a snap and feel it latch. Make sure that
you securely fasten the tongue in the
buckle.

To unfasten, press the release button
and remove the tongue from the buckle.
read more