Lincoln Aviator: Automatic Transmission - 10-Speed Automatic Transmission – 10R60 / Diagnosis and Testing - D Clutch

Symptom Chart

D Clutch

For D clutch operation,
REFER to: D Clutch (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Description and Operation).


  D Clutch


Condition Possible Sources Action
D clutch does not apply SSD mechanically stuck OFF INSTALL a new solenoid.
REFER to: Shift Solenoids (SS) (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch control valve stuck OFF DISASSEMBLE, CLEAN and INSPECT the D clutch control valve. If the bore or valve is damaged, INSTALL a new main control valve body.
REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch hydraulic circuits blocked/leaking DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary.
REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
If a leak is detected, INSPECT the front support assembly, input shaft Teflon seals and D clutch piston seals for leaks. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
CDF clutch cylinder, planetary carrier no. 3 DISASSEMBLE and INSPECT the CDF clutch cylinder and planetary carrier no. 3 for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch piston seals DISASSEMBLE and INSPECT the D clutch piston seals for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch friction plates DISASSEMBLE and INSPECT the D clutch friction and steel plates for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch always applied SSD mechanically stuck ON INSTALL a new solenoid.
REFER to: Shift Solenoids (SS) (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch control valve stuck ON DISASSEMBLE, CLEAN and INSPECT the D clutch control valve. If the bore or valve is damaged, INSTALL a new main control valve body.
REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch hydraulic circuit cross leaks DISASSEMBLE and INSPECT the main control valve body and separator plate passages for cracks, warping and damage. If damage is found, INSTALL a new main control valve body.
REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
CDF clutch cylinder, planetary carrier no. 3 DISASSEMBLE and INSPECT the components for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch piston return spring DISASSEMBLE and INSPECT the D clutch piston return spring for damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch friction plates DISASSEMBLE and INSPECT the D clutch friction and steel plates for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch delayed/soft/slipping apply Incorrect transmission strategy programmed into PCM/ TCM. CARRY OUT the Transmission Strategy Download and the Adaptive Learning Drive Cycle.
REFER to: Transmission Strategy Download (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, General Procedures).
REFER to: Adaptive Learning Drive Cycle (307-01B Automatic Transmission - 10-Speed Automatic Transmission – 10R80 MHT, General Procedures).
Low line pressure CARRY OUT the line pressure test. If line pressure is low, REFER to the Line Pressure Diagnosis Chart.
REFER to: Special Testing Procedures (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Diagnosis and Testing).
SSD mechanically sticking
  • If the vehicle has less than 5,000 miles (8,000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool.
  • For all other vehicles, INSTALL a new solenoid.
    REFER to: Shift Solenoids (SS) (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D Clutch control valve sticking
  • If the vehicle has less than 5,000 miles (8,000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool.
  • For all other vehicles, DISASSEMBLE, CLEAN and INSPECT the D clutch control valve. If the bore or valve is damaged, INSTALL a new main control valve body.
    REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch hydraulic circuits blocked/leaking DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris, blockage and leaks. CLEAN as necessary.
REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
CARRY OUT the air pressure test on the D clutch.
REFER to: Special Testing Procedures (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Diagnosis and Testing).
If a leak is detected, INSPECT the front support assembly, input shaft Teflon seals and D clutch piston seals for leaks. INSTALL new components as necessary. REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch piston seals DISASSEMBLE and INSPECT the D clutch piston seals for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch friction plates DISASSEMBLE and INSPECT the D clutch friction and steel plates for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch harsh apply Incorrect transmission strategy programmed into PCM/ TCM. CARRY OUT the Transmission Strategy Download and the Adaptive Learning Drive Cycle.
REFER to: Transmission Strategy Download (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, General Procedures).
REFER to: Adaptive Learning Drive Cycle (307-01B Automatic Transmission - 10-Speed Automatic Transmission – 10R80 MHT, General Procedures).
High line pressure CARRY OUT the line pressure test. If line pressure is high, REFER to the Line Pressure Diagnosis Chart.
REFER to: Special Testing Procedures (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Diagnosis and Testing).
SSD mechanically sticking
  • If the vehicle has less than 5,000 miles (8,000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool.
  • For all other vehicles, INSTALL a new solenoid.
    REFER to: Shift Solenoids (SS) (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch control valve sticking
  • If the vehicle has less than 5,000 miles (8,000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool.
  • For all other vehicles, DISASSEMBLE, CLEAN and INSPECT the D clutch control valve. If the bore or valve is damaged, INSTALL a new main control valve body.
    REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch hydraulic circuits blocked/leaking DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris, blockage and leaks. CLEAN as necessary.
REFER to: Main Control Valve Body (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Removal and Installation).
D clutch piston return spring DISASSEMBLE and INSPECT the D clutch piston return spring for damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).
D clutch friction plates DISASSEMBLE and INSPECT the D clutch friction and steel plates for wear and damage. INSTALL new components as necessary.
REFER to: Transmission (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Overhaul).

    Diagnosis and Testing - C Clutch

    Symptom Chart C Clutch For C clutch operation, REFER to: C Clutch (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Description and Operation)...

    Diagnosis and Testing - E Clutch

    Symptom Chart E Clutch For E clutch operation, REFER to: E Clutch (307-01A Automatic Transmission - 10-Speed Automatic Transmission – 10R60, Description and Operation)...

    Other information:

    Lincoln Aviator 2020-2025 Service Manual: Removal and Installation - Axle Shaft Seal


    Special Tool(s) / General Equipment 205-907Handle, 32 DriverTKIT-2008DH-FLM 307-256 (T92P-77000-FH) Installer, Differential Fluid SealTKIT-1992-FLMH/LMH Removal NOTE: The stub shaft seals must be replaced whenever the halfshafts are removed...

    Lincoln Aviator 2020-2025 Owners Manual: Plug-In Hybrid Vehicle Operation


    Regularly plug in your vehicle to get optimal electric-only range capability from the high voltage battery. Charging your vehicle adds electrical energy. This energy propels the vehicle. Estimated electric-only driving range shows in blue next to the gasoline range on the information display...

    Categories

    Seatbelt Height Adjustment

    WARNING: Position the seatbelt height adjuster so that the seatbelt rests across the middle of your shoulder. Failure to adjust the seatbelt correctly could reduce its effectiveness and increase the risk of injury in a crash.

    Adjust the height of the shoulder belt so the belt rests across the middle of your shoulder. Slide the adjuster up to raise the belt. Press the button and slide it down to lower the belt.

    read more

     
    Copyright © 2025 www.liaviator2.com