Lincoln Aviator: Front End Body Panels / Removal and Installation - Cowl Panel Grille
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the wiper pivot arms.
Refer to: Windshield Wiper Pivot Arm (501-16 Wipers and Washers, Removal and Installation).
-
Remove the retainers and the RH side engine compartment cover.
-
Remove the retainers and the LH side engine compartment cover.
-
-
Detach the wiper fluid hose coupling and position aside the wiper hose.
-
Remove the retainers and the RH side cowl panel grille.
-
Remove the retainers and the LH side cowl panel grille.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the wiper linkage assembly.
Refer to: Wiper Linkage Assembly (501-16 Wipers and Washers, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting)
...
Other information:
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Valve guides tend to wear in an hourglass pattern.
The ball gauge can be inserted into the combustion chamber side of the
valve guide, if necessary.
Use a ball gauge to determine the inside diameter of
the valve guides in 2 directions at the top, middle and bottom of the
valve guide...
Overview
The ACC system is controlled by the PCM, CCM and the IPMA.
The ACC modes are selected from the steering wheel mounted switches.
The gap control setting is selected from the lower right steering wheel switch.
ACC gap feature
uses radar and camera sensors to adjust vehicle speed to maintain the
set gap between the two vehicles in the same lane...