Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...
Special Tool(s) /
General Equipment
204-594Forcing screw
307-549Installer, Shift Shaft Fluid SealTKIT-2005D1-F1
307-648Remover/Installer, Rear BearingTKIT-2009C-FTKIT-2009C-ROW
307-745Installer, Park Sleeve Roll Pin
307-781Needle bearing remover/Installer
307-788Installer, sleeve
307-789Installer, sleeve
NOTE:
This step is only necessary if the transmission case is
being replaced...