Lincoln Aviator: 911 Assist
Due to the quiet operation of hybrid and
electric vehicles at low speeds, the system
creates a subtle sound to alert pedestrians.
The system is on when your vehicle is
running and not in park (P)...
911 Assist is a SYNC system feature that can
call for help if you are in an accident. If a
crash deploys an airbag, excluding knee
airbags and rear inflatable seatbelts [if
equipped], or activates the fuel pump
shut-off, your SYNC-equipped vehicle may
be able to contact emergency services by
dialing 911 through a paired and connected
Bluetooth enabled phone...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B10C7:01
Interior Trunk Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B10C9:01
Interior Front Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B10D7:05
PATS Key: System Programming Faliure:
GO to Pinpoint Test C
BCM
B10D7:55
PATS Key: Not Configured:
GO to Pinpoint Test D
BCM
B10D8:00
PATS Key Less Than Minimum Programmed: No Sub Type Information:
GO to Pinpoint Test E
BCM
B10DA:51
PATS Target Identifier: Not Programmed:
GO to Pinpoint Test F
BCM
B1336:01
Left Front Door External Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B1337:01
Right Front Door External Antenna: General Electrical Failure
GO to Pinpoint Test A
PCM
P161A:00
Incorrect Response from Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
PCM
P161B:00
Incorrect Response from Secondary Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
SOBDMC
P161A:00
Incorrect Response from Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
Symptom Chart
Symptom Chart: PATS
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the electrical connector...