Lincoln Aviator: Intake Air Distribution and Filtering - 3.0L EcoBoost/3.0L EcoBoost – Hybrid (BQ) / Description and Operation - Intake Air Distribution and Filtering - Overview
Overview
The
air intake system cleans intake air with a replaceable, dry-type engine
Air Cleaner (ACL) element made of treated, pleated paper. A new Air
Cleaner (ACL) element must be installed periodically as scheduled.
Engine performance and fuel economy are adversely affected when maximum
restriction of the Air Cleaner (ACL) element is reached.
The CAC subsystem cools and increases the density of the compressed turbocharged air.
The air intake system measures air temperature with the IAT sensor.
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Open the door.
Remove the check arm bolt.
Torque:
18 lb.ft (25 Nm)
Disconnect the rear door electrical connector...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
PCM
P060D:00
Internal Control Module Accelerator Pedal Position Performance: No Sub Type Information
GO to Pinpoint Test DK
PCM
P1575:00
Pedal Position Out Of Self Test Range: No Sub Type Information
GO to Pinpoint Test DK
PCM
P2122:00
Throttle/Pedal Position Sensor/Switch D Circuit Low: No Sub Type Information
GO to Pinpoint Test DK
PCM
P2123:00
Throttle/Pedal Position Sensor/Switch D Circuit High: No Sub Type Information
GO to Pinpoint Test DK
PCM
P2127:00
Throttle/Pedal Position Sensor/Switch E Circuit Low: No Sub Type Information
GO to Pinpoint Test DK
PCM
P2128:00
Throttle/Pedal Position Sensor/Switch E Circuit High: No Sub Type Information
GO to Pinpoint Test DK
PCM
P2138:00
Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation: No Sub Type Information
GO to Pinpoint Test DK
Global Customer Symptom Code (GCSC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Categories
The front outboard and rear safety restraints
in the vehicle are combination lap and
shoulder belts.
Insert the belt tongue into the proper
buckle (the buckle closest to the direction
the tongue is coming from) until you hear
a snap and feel it latch. Make sure that
you securely fasten the tongue in the
buckle.

To unfasten, press the release button
and remove the tongue from the buckle.
read more