Lincoln Aviator: Engine Emission Control - 3.0L EcoBoost / Diagnosis and Testing - Engine Emission Control
Diagnostics
in this manual assume a certain skill level and knowledge of
Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
For a PCM
DTC,
REFER to: Electronic Engine Controls (303-14C)
.
For driveability symptoms without a DTC, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 3, Symptom Charts.
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the PCV valve quick release coupling.
Refer to: Quick Release Coupling (310-00A Fuel System - General Information - 3...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B10C7:01
Interior Trunk Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B10C9:01
Interior Front Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B10D7:05
PATS Key: System Programming Faliure:
GO to Pinpoint Test C
BCM
B10D7:55
PATS Key: Not Configured:
GO to Pinpoint Test D
BCM
B10D8:00
PATS Key Less Than Minimum Programmed: No Sub Type Information:
GO to Pinpoint Test E
BCM
B10DA:51
PATS Target Identifier: Not Programmed:
GO to Pinpoint Test F
BCM
B1336:01
Left Front Door External Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B1337:01
Right Front Door External Antenna: General Electrical Failure
GO to Pinpoint Test A
PCM
P161A:00
Incorrect Response from Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
PCM
P161B:00
Incorrect Response from Secondary Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
SOBDMC
P161A:00
Incorrect Response from Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
Symptom Chart
Symptom Chart: PATS
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the diagnostic scan tool
prior to removing the module. This information must be downloaded into
the new module after installation...