Lincoln Aviator: Auxiliary Power Points / Wireless Accessory Charger (If Equipped)
WARNING: Wireless charging
devices can affect the operation of
implanted medical devices, including
cardiac pacemakers. If you have any
implanted medical devices, we recommend
that you consult with your physician.
Note: Devices without built-in Qi wireless
charging receivers require an additional Qi
receiver or sleeve.
The system supports one Qi wireless
charging compatible device on the charging
area.
Keep the charging area clean and remove
foreign objects prior to charging a device.
Do not place items with a magnetic strip, for
example passports, parking tickets or credit
cards, near the charging area when charging
a device. Damage may occur to the magnetic
strip.
Do not place metal objects, for example
remote controls, coins and candy wrappers,
on or near the charging area when charging
a device. Metal objects may heat up and
degrade the charging performance.
Note: The rate of charge, or charging power,
is controlled by the device. During charging,
the device and the charger may heat up, this
is normal. If the battery gets hotter than
usual, the charger may stop charging.
To begin charging, place the
device on the charging icon with
the charging side down.

The charging area is in the center console.
You can charge a device if the vehicle is on,
when in accessory mode or when SYNC is
on. The charging stops after your device
reaches a full charge.
Note: If the system detects a foreign object
or if the device is misaligned on the charging
area, a message appears in the display.
Note: Software and firmware updates may
affect device compatibility, including the use
of unofficial software or firmware. Customers
should verify charging functionality with their
specific devices in-vehicle.

This equipment has been tested and found
to comply with Part 18 of the FCC Rules.
- This equipment generates, uses, and can
radiate radio frequency energy and may
cause harmful interference to radio
communications. There is no guarantee
that interference will not occur in a
particular installation. If this equipment
does cause harmful interference to radio
or television reception, please consult
the dealer.
- This product is not end-user serviceable.
FCC ID: L2C0074TR
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic
Development Canada’s licence-exempt
RSS(s). Operation is subject to the following
two conditions:
- This device may not cause interference,
and
- This device must accept any interference,
including interference that may cause
undesired operation of the device.
IC ID: 3432A-0074TR
WARNING: Do not keep electrical
devices plugged in the power point
whenever the device is not in use. Do not
use any extension cord with the 110 volt
AC power point, since it will defeat the
safety protection design...
Other information:
Materials
Name
Specification
Motorcraft® SAE 75W-140 Synthetic Rear Axle LubricantXY-75W140-QL
WSL-M2C192-A
Removal
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation)...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
ABS
B1111:4B
Electric Park Brake Enable:Over Temperature
GO to Pinpoint Test F
ABS
B1111:53
Electric Park Brake Enable:Deactivated
GO to Pinpoint Test G
ABS
B1111:54
Electric Park Brake Enable:Missing Calibration
GO to Pinpoint Test E
ABS
C0609:01
Park Brake Switch Circuit:General Electrical Failure
GO to Pinpoint Test B
ABS
C0616:9A
Park Brake Control Module Control Circuit Performance:Component or System Operating Conditions
GO to Pinpoint Test B
ABS
C1034:01
Park Brake:General Electrical Failure
GO to Pinpoint Test B
ABS
C1034:07
Park Brake:Mechanical Failures
GO to Pinpoint Test K
ABS
C1034:13
Park Brake:Circuit Open
GO to Pinpoint Test B
ABS
C1034:25
Park Brake:Signal Shape/Waveform Failure
GO to Pinpoint Test B
ABS
C1034:2F
Park Brake:Signal Erratic
GO to Pinpoint Test B
ABS
C1034:47
Park Brake:Watchdog/Safety µC Failure
GO to Pinpoint Test B
ABS
C1034:48
Park Brake:Supervision Software Failure
GO to Pinpoint Test B
ABS
C1034:57
Park Brake:Invalid/Incompatible Software Component
GO to Pinpoint Test B
ABS
C1034:71
Park Brake:Actuator Stuck
GO to Pinpoint Test C
ABS
C1034:77
Park Brake:Commanded Position Not Reachable
GO to Pinpoint Test C
ABS
C1034:78
Park Brake:Alignment Or Adjustment Incorrect
GO to Pinpoint Test H
ABS
C1034:97
Park Brake:Component or System Operation Obstructed or Blocked
GO to Pinpoint Test D
ABS
C1A43:98
Motor Supply:Component or System Over Temperature
GO to Pinpoint Test D
ABS
C2005:18
Right Actuator:Circuit Current Below Threshold
GO to Pinpoint Test D
ABS
C2005:19
Right Actuator:Circuit Current Above Threshold
GO to Pinpoint Test D
ABS
C2005:77
Right Actuator:Commanded Position Not Reachable
GO to Pinpoint Test C
ABS
C2005:78
Right Actuator:Alignment Or Adjustment Incorrect
GO to Pinpoint Test A
ABS
C2006:18
Left Actuator:Circuit Current Below Threshold
GO to Pinpoint Test D
ABS
C2006:19
Left Actuator:Circuit Current Above Threshold
GO to Pinpoint Test D
ABS
C2006:77
Left Actuator:Commanded Position Not Reachable
GO to Pinpoint Test C
ABS
C2006:78
Left Actuator:Alignment Or Adjustment Incorrect
GO to Pinpoint Test A
ABS
C2007:13
Right Motor:Circuit Open
GO to Pinpoint Test D
ABS
C2007:1C
Right Motor:Circuit Voltage Out Of Range
GO to Pinpoint Test D
ABS
C2007:92
Right Motor:Performance Or Incorrect Operation
GO to Pinpoint Test D
ABS
C2008:13
Left Motor:Circuit Open
GO to Pinpoint Test D
ABS
C2008:1C
Left Motor:Circuit Voltage Out Of Range
GO to Pinpoint Test D
ABS
C2008:92
Left Motor:Performance Or Incorrect Operation
GO to Pinpoint Test D
ABS
U2002:00
Switch:No Sub Type Information
GO to Pinpoint Test J
ABS
U2002:47
Switch:Watchdog/Safety µC Failure
GO to Pinpoint Test B
Symptom Chart(s)
Symptom Chart: Parking Brake and Actuation
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...