Lincoln Aviator: Windows and Mirrors / Interior Mirror
WARNING: Do not adjust the mirrors
when your vehicle is moving. This could
result in the loss of control of your vehicle,
serious personal injury or death.
Note: Do not clean the housing or glass of
any mirror with harsh abrasives, fuel or other
petroleum or ammonia-based cleaning
products.
You can adjust the interior mirror to your
preference. Some mirrors also have a second
pivot point. This lets you move the mirror
head up or down and from side to side.
Auto-Dimming Mirror
Note: Do not block the sensors on the front
and back of the mirror. A rear center
passenger or raised rear center head
restraint may also block light from reaching
the sensor.
The mirror dims to reduce the effect of bright
light from behind. It returns to normal when
the bright light from behind is no longer
present or if you shift into reverse (R).
Power Exterior Mirrors
WARNING: Do not adjust the mirrors
when your vehicle is moving. This could
result in the loss of control of your vehicle,
serious personal injury or death...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B130F:12
Run Accessory Control: Circuit Short To Battery
GO to Pinpoint Test A
BCM
B130F:14
Run Accessory Control: Circuit Short To Ground or Open
GO to Pinpoint Test A
BCM
B130F:14
Run Accessory Control: Circuit Short To Ground or Open
GO to Pinpoint Test D
SCCM
B10AD:02
Rain Sensor: General Signal Failure
GO to Pinpoint Test F
SCCM
B10AD:08
Rain Sensor: Bus Signal / Message Failure
GO to Pinpoint Test F
SCCM
B10AD:49
Rain Sensor:Internal Electronic Failure
GO to Pinpoint Test Q
SCCM
B10AD:55
:Rain Sensor:Not Configured
GO to Pinpoint Test P
SCCM
B1131:02
Wiper motor module: General Signal Failure
GO to Pinpoint Test A
SCCM
B1131:02
Wiper Motor Module: General Signal Failure
GO to Pinpoint Test D
SCCM
B1131:08
Wiper motor module: Bus Signal / Message Failure
GO to Pinpoint Test B
SCCM
B1131:11
Wiper motor module: Circuit Short to Ground
GO to Pinpoint Test B
SCCM
B1131:49
Wiper Motor Module:Internal Electronic Failure
GO to Pinpoint Test R
SCCM
B1131:55
:Wiper Motor Module: Not Configured
GO to Pinpoint Test P
SCCM
B124E:11
Wiper Stalk Switch Pack: Circuit Short To Ground
GO to Pinpoint Test V
SCCM
B124E:13
Wiper Stalk Switch Pack: Circuit Open
GO to Pinpoint Test V
SCCM
B124E:55
Wiper Stalk Switch: Not Configured
GO to Pinpoint Test V
SCCM
B124E:96
Wiper Stalk Switch Pack: Component Internal Failure
GO to Pinpoint Test V
SCCM
B124E:9E
Wiper Stalk Switch Pack: Stuck On
GO to Pinpoint Test V
Symptom Chart
Symptom Chart: Wiper and Washer
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service expense. Use the same or equivalent parts if
replacement is necessary. Do not use a replacement part of lesser
quality or substitute design...