Lincoln Aviator: Rear View Camera / Manual Zoom
WARNING: When manual zoom is
on, the full area behind your vehicle may
not show. Be aware of your surroundings
when using the manual zoom feature.
Note: Manual zoom is only available when
the transmission is in reverse (R).
Note: When you enable manual zoom, only
the centerline is shown.
Selectable settings for this feature are Zoom
in (+) and Zoom out (-). Press the symbol in
the camera screen to change the view. The
default setting is Zoom OFF.
This allows you to get a closer view of an
object behind your vehicle. The zoomed
image keeps the bumper in the image to
provide a reference. The zoom is only active
while the transmission is in reverse (R).
Press the camera button while in park (P),
neutral (N) or drive (D) and under a speed of
6 mph (10 km/h) to bring up the rear camera
view in the display screen...
Selectable settings for this feature are ON
and OFF.
The default setting for the rear camera delay
is OFF.
When shifting the transmission out of reverse
(R) and into any gear other than park (P), the
camera image remains in the display until:
Your vehicle speed reaches
approximately 5 mph (8 km/h)...
Other information:
System Operation
Headlamps - Low Series
System Diagram
Item
Description
1
HS-CAN2
2
BCM
3
LH low beam
4
LH high beam
5
RH low beam
6
RH high beam
7
SCCM
8
LH steering column multifunction switch
9
IPMA
10
GWM
11
HS-CAN1
12
Start/Stop switch
13
HCM
14
LIN
15
LIN
16
PCM
17
LH headlamp
18
RH headlamp
19
LH front suspension height sensor
20
LH rear suspension height sensor
21
Headlamp switch
22
(If equipped automatic headlamp leveling)
23
LIN
24
LIN
Network Message Chart
BCM Network Input Messages
Broadcast Message
Originating Module
Message Purpose
Headlamp flash to pass status
GWM
Indicates to the BCM a request for the high beams or flash-to-pass...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the LH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Position the subwoofer assembly to access rear connectors...
Categories
The front outboard and rear safety restraints
in the vehicle are combination lap and
shoulder belts.
Insert the belt tongue into the proper
buckle (the buckle closest to the direction
the tongue is coming from) until you hear
a snap and feel it latch. Make sure that
you securely fasten the tongue in the
buckle.

To unfasten, press the release button
and remove the tongue from the buckle.
read more