Lincoln Aviator: Brake System / Power Brake Actuation
Removal
NOTICE:
Siphon the brake fluid from the HCU/EBB reservoir, if the
reservoir is not emptied there will be a large amount of brake fluid
spilled in the engine compartment...
Electric Brake Boost
Overview
The power assisted brake system utilizes an EBB. The EBB is an integrated function of the ABS / HCU assembly and is controlled by the ABS module...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
IPMB
B129C:08
Left Front Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test A
IPMB
B129C:96
Left Front Side Sensor: Component Internal Failure
GO to Pinpoint Test E
IPMB
B129C:98
Left Front Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
IPMB
B129D:08
Right Front Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test B
IPMB
B129D:96
Right Front Side Sensor: Component Internal Failure
GO to Pinpoint Test E
IPMB
B129D:98
Right Front Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
IPMB
B13F3:08
Left Rear Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test C
IPMB
B13F3:96
Left Rear Side Sensor: Component Internal Failure
GO to Pinpoint Test G
IPMB
B13F3:98
Left Rear Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
IPMB
B13F4:08
Right Rear Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test D
IPMB
B13F4:96
Right Rear Side Sensor: Component Internal Failure
GO to Pinpoint Test G
IPMB
B13F4:98
Right Rear Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
Symptom Chart(s)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Programming
NOTE:
This procedure works only if the spare key programming is enabled.
NOTE:
Two previously programmed keys are required to perform this
procedure. All the steps must be completed within 30 seconds.
NOTE:
Make sure all the doors are closed prior to beginning this
procedure and they remain closed until the procedure is complete...