Lincoln Aviator: Rear Occupant Alert System / Rear Occupant Alert System Indicators and Audible Warnings
Indicators

Message
Check rear seats for occupants.
Displays when you switch your vehicle off
after the alert conditions are met.
The message displays for a short period of
time. Press Close to acknowledge and
remove the message.
Audible Warnings
Sounds when you switch your vehicle off
after the alert conditions are met.
The warning sounds for a short period of
time.
Press Settings on the touchscreen.
Press Vehicle.
Switch Rear Occupant Alert on or off.
Note: Performing a master reset causes the
system to switch on again...
HomeLink Wireless Control System
WARNING: Do not use the system
with any garage door opener that does not
have the safety stop and reverse feature
as required by U...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Disconnect the batteries.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
Disconnect the vent hose from the auxiliary battery...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
IPMB
B1303:13
Park Assist Switch:Circuit Open
GO to Pinpoint Test D
IPMB
B1303:9E
Park Assist Switch:Stuck On
GO to Pinpoint Test D
IPMB
B1B36:08
Right Front Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test I
IPMB
B1B36:96
Right Front Outer Sensor: Component Internal Failure
GO to Pinpoint Test N
IPMB
B1B36:98
Right Front Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
IPMB
B1B38:08
Right Front Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test J
IPMB
B1B38:96
Right Front Inner Sensor: Component Internal Failure
GO to Pinpoint Test N
IPMB
B1B38:98
Right Front Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
IPMB
B1B40:08
Left Front Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test K
IPMB
B1B40:96
Left Front Outer Sensor: Component Internal Failure
GO to Pinpoint Test N
IPMB
B1B40:98
Left Front Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
IPMB
B1B42:08
Left Front Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test L
IPMB
B1B42:96
Left Front Inner Sensor: Component Internal Failure
GO to Pinpoint Test N
IPMB
B1B42:98
Left Front Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
IPMB
B1B44:08
Right Rear Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test E
IPMB
B1B44:96
Right Rear Outer Sensor: Component Internal Failure
GO to Pinpoint Test M
IPMB
B1B44:98
Right Rear Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
IPMB
B1B46:08
Right Rear Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test F
IPMB
B1B46:96
Right Rear Inner Sensor: Component Internal Failure
GO to Pinpoint Test M
IPMB
B1B46:98
Right Rear Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
IPMB
B1B48:08
Left Rear Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test G
IPMB
B1B48:96
Left Rear Outer Sensor: Component Internal Failure
GO to Pinpoint Test M
IPMB
B1B48:98
Left Rear Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
IPMB
B1B50:08
Left Rear Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test H
IPMB
B1B50:96
Left Rear Inner Sensor: Component Internal Failure
GO to Pinpoint Test M
IPMB
B1B50:98
Left Rear Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
IPMB
B1B57:11
Front Sensors Power Circuit: Circuit Short To Ground
GO to Pinpoint Test B
IPMB
B1B58:11
Rear Sensors Power Circuit: Circuit Short To Ground
GO to Pinpoint Test C
IPMB
U0428:00
Invalid Data Received From Steering Angle Sensor Module:No Sub Type Information
GO to Pinpoint Test Z
PAM
B1303:13
Park Assist Switch:Circuit Open
GO to Pinpoint Test D
PAM
B1303:9E
Park Assist Switch:Stuck On
GO to Pinpoint Test D
PAM
B1B36:08
Right Front Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test I
PAM
B1B36:1F
Right Front Outer Sensor:Circuit Intermittent
GO to Pinpoint Test I
PAM
B1B36:31
Right Front Outer Sensor:No Signal
GO to Pinpoint Test I
PAM
B1B36:96
Right Front Outer Sensor: Component Internal Failure
GO to Pinpoint Test N
PAM
B1B36:98
Right Front Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
PAM
B1B38:08
Right Front Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test J
PAM
B1B38:1F
Right Front Inner Sensor:Circuit Intermittent
GO to Pinpoint Test J
PAM
B1B38:31
Right Front Inner Sensor:No Signal
GO to Pinpoint Test J
PAM
B1B38:96
Right Front Inner Sensor: Component Internal Failure
GO to Pinpoint Test N
PAM
B1B38:98
Right Front Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
PAM
B1B40:08
Left Front Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test K
PAM
B1B40:1F
Left Front Outer Sensor:Circuit Intermittent
GO to Pinpoint Test K
PAM
B1B40:31
Left Front Outer Sensor:No Signal
GO to Pinpoint Test K
PAM
B1B40:96
Left Front Outer Sensor: Component Internal Failure
GO to Pinpoint Test N
PAM
B1B40:98
Left Front Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
PAM
B1B42:08
Left Front Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test L
PAM
B1B42:1F
Left Front Inner Sensor:Circuit Intermittent
GO to Pinpoint Test L
PAM
B1B42:31
Left Front Inner Sensor:No Signal
GO to Pinpoint Test L
PAM
B1B42:96
Left Front Inner Sensor: Component Internal Failure
GO to Pinpoint Test N
PAM
B1B42:98
Left Front Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test O
PAM
B1B44:08
Right Rear Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test E
PAM
B1B44:1F
Right Rear Outer Sensor:Circuit Intermittent
GO to Pinpoint Test E
PAM
B1B44:31
Right Rear Outer Sensor:No Signal
GO to Pinpoint Test E
PAM
B1B44:96
Right Rear Outer Sensor: Component Internal Failure
GO to Pinpoint Test M
PAM
B1B44:98
Right Rear Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
PAM
B1B46:08
Right Rear Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test F
PAM
B1B46:1F
Right Rear Inner Sensor:Circuit Intermittent
GO to Pinpoint Test F
PAM
B1B46:31
Right Rear Inner Sensor:No Signal
GO to Pinpoint Test F
PAM
B1B46:96
Right Rear Inner Sensor: Component Internal Failure
GO to Pinpoint Test M
PAM
B1B46:98
Right Rear Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
PAM
B1B48:08
Left Rear Outer Sensor:Bus Signal/Message Failure
GO to Pinpoint Test G
PAM
B1B48:1F
Left Rear Outer Sensor:Circuit Intermittent
GO to Pinpoint Test G
PAM
B1B48:31
Left Rear Outer Sensor:No Signal
GO to Pinpoint Test G
PAM
B1B48:96
Left Rear Outer Sensor: Component Internal Failure
GO to Pinpoint Test M
PAM
B1B48:98
Left Rear Outer Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
PAM
B1B50:08
Left Rear Inner Sensor:Bus Signal/Message Failure
GO to Pinpoint Test H
PAM
B1B50:1F
Left Rear Inner Sensor:Circuit Intermittent
GO to Pinpoint Test H
PAM
B1B50:31
Left Rear Inner Sensor:No Signal
GO to Pinpoint Test H
PAM
B1B50:96
Left Rear Inner Sensor: Component Internal Failure
GO to Pinpoint Test M
PAM
B1B50:98
Left Rear Inner Sensor:Component Or System Over Temperature
GO to Pinpoint Test P
PAM
B1B57:11
Front Sensors Power Circuit: Circuit Short To Ground
GO to Pinpoint Test B
PAM
B1B58:11
Rear Sensors Power Circuit: Circuit Short To Ground
GO to Pinpoint Test C
PAM
U0100:00
Lost Communication With ECM/PCM "A": No Sub Type Information
GO to Pinpoint Test R
PAM
U0121:00
Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information
GO to Pinpoint Test S
PAM
U0131:00
Lost Communication With Power Steering Control Module: No Sub-Type Information
GO to Pinpoint Test T
PAM
U0138:00
Lost Communication with All Terrain Control Module:No Sub Type Information
GO to Pinpoint Test U
PAM
U0140:00
Lost Communication With Body Control Module: No Sub Type Information
GO to Pinpoint Test V
PAM
U0146:00
Lost Communication With Gateway "A": No Sub Type Information
GO to Pinpoint Test W
PAM
U0155:00
Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information
GO to Pinpoint Test X
PAM
U0164:00
Lost Communication With HVAC Control Module: No Sub Type Information
GO to Pinpoint Test Y
PAM
U0212:00
Lost Communication With Steering Column Control Module: No Sub Type Information
GO to Pinpoint Test AB
PAM
U0252:00
Lost Communication With Lighting Control Module- Rear "B": No Sub Type Information
GO to Pinpoint Test AC
PAM
U0293:00
Lost Communication with Hybrid/EV Powertrain Control Module:No Sub Type Information
GO to Pinpoint Test R
PAM
U0300:57
Internal Control Module Software Incompatibility:Invalid/Incompatible Software Component
GO to Pinpoint Test AG
PAM
U0401:00
Invalid Data Received from ECM/PCM A:No Sub Type Information
GO to Pinpoint Test R
PAM
U0415:00
Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A":No Sub Type Information
GO to Pinpoint Test S
PAM
U0420:00
Invalid Data Received from Power Steering Control Module "A":No Sub Type Information
GO to Pinpoint Test T
PAM
U0422:00
Invalid Data Received From Body Control Module:No Sub Type Information
GO to Pinpoint Test V
PAM
U0423:82
Invalid Data Received from Instrument Panel
Cluster Control Module:Alive/Sequence Counter Incorrect/Not Updated
GO to Pinpoint Test X
PAM
U0424:00
Invalid Data Received From HVAC Control Module:No Sub Type Information
GO to Pinpoint Test Y
PAM
U0424:82
Invalid Data Received From HVAC Control Module:Alive/Sequence Counter Incorrect/Not Updated
GO to Pinpoint Test Y
PAM
U0485:82
Invalid Data Received From Radio:Alive/Sequence Counter Incorrect/Not Updated
GO to Pinpoint Test AA
PAM
U0553:82
Invalid Data Received From Lighting Control
Module-Rear "B":Alive/Sequence Counter Incorrect/Not Updated
GO to Pinpoint Test AC
PAM
U0554:00
Invalid Data Received From Accessory Protocol Interface Module:No Sub Type Information
GO to Pinpoint Test AD
PAM
U0554:82
Invalid Data Received From Accessory
Protocol Interface Module:Alive/Sequence Counter Incorrect/Not Updated
GO to Pinpoint Test AD
PAM
U0594:00
Invalid Data Received From Hybrid/EV Powertrain Control Module:No Sub Type Information
GO to Pinpoint Test R
PAM
U1000:00
Solid State Driver Protection Active -Driver Disabled:No Sub Type Information
GO to Pinpoint Test AE
PAM
U2024:41
Control Module Cal-Config Data:General Checksum Failure
GO to Pinpoint Test AF
PAM
U2100:00
Initial Configuration Not Complete:No Sub Type Information
GO to Pinpoint Test AF
PAM
U2101:00
Control Module Configuration Incompatible:No Sub Type Information
GO to Pinpoint Test AF
PAM
U3000:44
Control Module:Data Memory Failure
GO to Pinpoint Test AG
PAM
U3000:45
Control Module:Program Memory Failure
GO to Pinpoint Test AG
PAM
U3000:46
Control Module:Calibration/Parameter Memory Failure
GO to Pinpoint Test AG
PAM
U3000:49
Control Module:Internal Electronic Failure
GO to Pinpoint Test AG
Symptom Chart(s)
Symptom Chart: Parking Aid
Condition
Possible Sources
Actions
A module does not communicate with the diagnostic scan tool
Fuse
Wiring, terminals or connectors
PAM
IPMB
REFER to: Communications Network (418-00 Module Communications Network, Diagnosis and Testing)...