Lincoln Aviator: Cruise Control / Setting the Cruise Control Speed
WARNING: When you are going
downhill, your vehicle speed could
increase above the set speed. The system
does not apply the brakes.
Drive to the speed you prefer.
Press either button to set the
current speed.
Take your foot off the accelerator pedal.
Note: The indicator changes color in the
information display.
Changing the Set Speed
Press and release the button to
increase the set speed in small
increments.
Press and hold the button to accelerate.
Release the button when you reach your
preferred speed.
Press and release the button to
decrease the set speed in small
increments.
Press and hold the button to decelerate.
Release the button when you reach your
preferred speed.
Note: If you accelerate by pressing the
accelerator pedal, the set speed does not
change. When you release the accelerator
pedal, your vehicle returns to the speed that
you previously set.
WARNING: Do not use cruise control
on winding roads, in heavy traffic or when
the road surface is slippery. This could
result in loss of vehicle control, serious
injury or death...
Canceling
Press the button, or tap the
brake
pedal to cancel the set speed.
Note: The system remembers the set speed.
Note: The system cancels if the vehicle
speed drops below 10 mph (16 km/h) under
the set speed when driving uphill...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
IPMB
B129C:08
Left Front Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test A
IPMB
B129C:96
Left Front Side Sensor: Component Internal Failure
GO to Pinpoint Test E
IPMB
B129C:98
Left Front Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
IPMB
B129D:08
Right Front Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test B
IPMB
B129D:96
Right Front Side Sensor: Component Internal Failure
GO to Pinpoint Test E
IPMB
B129D:98
Right Front Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
IPMB
B13F3:08
Left Rear Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test C
IPMB
B13F3:96
Left Rear Side Sensor: Component Internal Failure
GO to Pinpoint Test G
IPMB
B13F3:98
Left Rear Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
IPMB
B13F4:08
Right Rear Side Sensor: Bus Signal / Message Failure
GO to Pinpoint Test D
IPMB
B13F4:96
Right Rear Side Sensor: Component Internal Failure
GO to Pinpoint Test G
IPMB
B13F4:98
Right Rear Side Sensor: Component or System Over Temperature
GO to Pinpoint Test F
Symptom Chart(s)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door window glass.
Refer to: Front Door Window Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation)...