Lincoln Aviator: Opening and Closing the Liftgate, Stopping the Liftgate Movement / Stopping the Liftgate Movement
Note: Do not apply sudden excessive force
to the liftgate while it is in motion. This could
damage the power liftgate and its
components.
You can stop the liftgate movement by doing
any of the following:
- Pressing the liftgate control button.
- Pressing the liftgate button on the remote
control twice.
- Pressing the liftgate button on the
instrument panel.
- Moving your foot under and away from
the center rear bumper in a single-kick
motion.*
*This method only works for vehicles with
the hands-free liftgate feature.
WARNING: Make sure all persons
are clear of the power liftgate area before
using the power liftgate control.
Note: Make sure the area behind your
vehicle is free from obstruction and that
there is enough room for you to operate the
liftgate...
Open the liftgate.
Stop the liftgate movement by pressing
the control button on the liftgate when it
reaches the desired height.Note: Once the liftgate has stopped
moving,
you can also manually move it to the desired
height...
Other information:
System Diagram
Item
Description
1
SOBDMC/ISC (Inverter System Controller)
2
APIM
3
FCIM
4
BCM
5
BMS
6
DCDC
7
PCM
8
GWM
9
BECM
10
SOBDM/BCCM (Battery Charger Control Module)
11
EVSE (Electric Vehicle Supply Equipment)
12
High Voltage Battery
13
High Voltage Battery Junction Box
14
CSI (Charge Status Indicator)
System Operation
Network Message Chart — SOBDM
Broadcast Message
Originating Module
Message Purpose
High voltage battery state of charge (SOC)
BECM
Used to notify other vehicle modules that the high voltage battery has reached 100% SOC
High voltage battery charge status (not
ready, charge wait, ready, charging, charge complete, fault)
BECM
Used to transition the charger between charging and ready states
Vehicle operating mode
Inverter System Controller (ISC)
Vehicle must be in non-torque producing mode prior to charging
Low voltage support
PCM
Used to activate the low voltage output and support the low voltage system
Gear lever position
PCM
Used to determine transaxle gear state
Ambient air temperature
PCM
Ambient air temperature used for cooling strategy
Maximum current request
BECM
Used to limit and set target setpoint of charger
Maximum voltage request
BECM
Used to limit and set target setpoint of charger
Charge contactor open/close
BECM
High voltage battery charge contactor command
12V battery charge setpoint command
PCM
This message is used to set the 12V battery charging voltage...
Guarding Against Exhaust Fumes
WARNING: Exhaust leaks may result
in entry of harmful and potentially lethal
fumes into the passenger compartment. If
you smell exhaust fumes inside your
vehicle, have your vehicle inspected
immediately. Do not drive if you smell
exhaust fumes...