Lincoln Aviator: All-Wheel Drive / Operating All-Wheel Drive (AWD) Vehicles With Spare Tires
Do not use a different size spare tire other
than the tire provided. If the mini-spare tire
is installed, the AWD system will disable and
enter rear-wheel drive only mode to protect
driveline components. Some limited AWD
traction could be provided if the mini-spare
is installed on one of the front wheels. If you
are in driving conditions where limited AWD
traction is needed while the mini-spare is
installed, it is recommended the mini-spare
be installed on the front axle.
If the mini-spare is installed, this condition is
indicated by a warning in the information
display.
The slip response system could activate if
the mini spare is installed on the front
wheels. If the mini spare was installed on the
rear wheels the slip response system will
fully disable. In situations where there is a
wintery mix or an off road situation, and you
need to use a mini spare, you must install
the mini spare in the front tire position and
move a full size tire to the rear tire position
for the slip response system to function.
WARNING: Vehicles with a higher
center of gravity (utility and four-wheel
drive vehicles) handle differently than
vehicles with a lower center of gravity
(passenger cars)...
WARNING: Only use replacement
tires and wheels that are the same size,
load index, speed rating and type (such as
P-metric versus LT-metric or all-season
versus all-terrain) as those originally
provided by Ford...
Other information:
WARNING: Do not keep electrical
devices plugged in the power point
whenever the device is not in use. Do not
use any extension cord with the 110 volt
AC power point, since it will defeat the
safety protection design. Doing so may
cause the power point to overload due to
powering multiple devices that can reach
beyond the 150 watt load limit and could
result in fire or serious injury...
Special Tool(s) /
General Equipment
100-001
(T50T-100-A)
Slide Hammer
100-002
(TOOL-4201-C)
Holding Fixture with Dial Indicator Gauge
205-1018Installation Tube
307-003
(T57L-500-B)
Holding Fixture, Transmission
307-091Handle, Torque ConverterTKIT-2009TC-F
307-309Remover, Torque Converter SealTKIT-1994-FMH/FLMHTKIT-1994-LMH/MHTKIT-1994-FH
307-346
(T97T-7902-A)
Retainer, Torque ConverterTKIT-1998-LM (NavigatoR)TKIT-1997-F/FLM/LT
307-549Installer, Shift Shaft Fluid SealTKIT-2005D1-F1
307-5842-6 Spring CompressorTKIT-2006UF-FLMTKIT-2006UF-ROW
307-589Overdrive clutch and balance piston service setTKIT-2006UF-FLMTKIT-2006UF-ROW
307-651Bracket, Pump Remover/Installer
307-651-02Lift fixture adapter for 307-651
307-661Gauge, End PlayTKIT-2009C-FTKIT-2009C-ROW
307-661-01Spacers/Plate, Clearance Gage
307-662Gauge, Clutch Pack EndplayTKIT-2009C-FTKIT-2009C-ROW
307-691Tester, Torque Convertor Leak
307-732Tool Kit, Torque Converter Flusher
307-732-02Adapter for 307-732 Converter flushing Mandrel
307-736Installer, Pump Drive Gear Bearing
307-737Press Tool, Oil Pump Drive Idler Gear
307-741Spring Compressor, F Clutch
307-743Remover, Pump Drive Gear
307-746Remover, Transmission Wiring Harness Connector
307-780Converter Seal installer
307-782Installer, Output Shaft Seal
307-783Installer, Roll Pin
307-784One way clutch alignment tool
307-785Clutch spring compressor
307-786F7 Seal Installer/Sizer Input Shaft
307-787F8 Seal Installer/Sizer Input Shaft
307-790Endplay Check Gauge
307-796F2 Seal Guide, Installer & Sizer
307-797Installer, Alignment Studs (3) & Alignment Pin (All 10R)
307-803F1 Seal Guide, Installer & Sizer
307-804F9 Seal Guide, Installer & Sizer
Rubber Mallet
Hydraulic Press
Punch
Wooden Block
Magnet
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
All vehicles
Transmission overhaul includes the following:
Complete disassembly of the transmission
Cleaning and inspecting of all components
Replacement of all seals, gaskets, and one time use components...