Lincoln Aviator: Climate Control System - General Information / Removal and Installation - Evaporator Temperature Sensor
Removal
-
NOTE:
The evaporator temperature sensor is available only as part of the evaporator.
Remove the evaporator.
Refer to: Evaporator (412-00 Climate Control System - General Information, Removal and Installation).
Installation
-
Transfer the components from the old housing to the new housing as needed.
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Removal
NOTE:
If a heater core leak is suspected, the heater core must be leak tested before it is removed from the vehicle.
Remove the climate control housing...
Other information:
System Operation
System Diagram
Item
Description
1
RGTM
2
Front Power Liftgate Switch
3
Exterior Liftgate Release Switch
4
Anti-Pinch Switches
5
BCM
6
Left/Right Power Liftgate Motors
7
Power Liftgate Latch
8
Cinch Motor
9
Latch/Cinch Switches
10
Hands-Free Liftgate Actuation Module
11
Hands-Free Liftgate Actuation Sensors
12
Rear Interior Power Liftgate Switch
13
GWM
14
IPC
15
GWM
16
ACM
17
Release Motor
18
Motor
19
Position Sensor
Network Message Chart
RGTM Network Input Messages
Broadcast Message
Originating Module
Message Purpose
Liftgate request
BCM
Used by the RGTM to open/close the liftgate when the BCM receives a valid request from a programmed RKE transmitter or the passive entry feature...
Special Tool(s) /
General Equipment
Air Conditioning Service Unit
Air Conditioning Adaptor Kit
Inspection
Recover the refrigerant. Refer to Air Conditioning (A/C)
System Recovery, Evacuation and Charging procedure in Group 412...