Lincoln Aviator: Handles, Locks, Latches and Entry Systems / Removal and Installation - Rear Door Latch Cinch Motor
Removal
NOTE:
The rear door latch cinch motor is serviced with the rear door latch.
-
Remove the rear door latch.
Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The PMI process must begin with the current door
latch control module installed...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the rear door window control switch bezel assembly...
Other information:
Special Tool(s) /
General Equipment
205-153
(T80T-4000-W)
Handle
307-758Installer, Axle Seal -FWD
Feeler Gauge
Flat Headed Screw Driver
Removal
NOTE:
The stub shaft seals must be replaced whenever the halfshafts are removed...
Overview
The IPC uses the following methods and functionality to alert the driver of vehicle conditions:
Gauges
Informational RTT and warning RTT indicators
Informational and instructional messages
Warning messages
Warning chimes
The IPC
uses a full width 12-inch screen to display driver information with
virtual gauges, with either a single gauge or dual gauge setup...