Lincoln Aviator: Rear Climate Control / Removal and Installation - Rear Heater Core Inlet Line
Removal
NOTE:
The rear heater core inlet line is installed from the
factory as a one-piece assembly. The replacement part is supplied as an
assembly, containing the rear heater core outlet line and the rear
evaporator inlet and outlet lines.
-
Remove the rear evaporator rear outlet and inlet line.
Refer to: Rear Evaporator Rear Outlet and Inlet Line (412-02A Rear Climate Control, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Hose Clamp Remover/Installer
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
The rear heater core outline is installed from the factory
as a one-piece assembly. The replacement part is supplied as an
assembly, containing the rear heater core inlet line and the rear
evaporator inlet and outlet lines...
Other information:
Adjustment
NOTE:
Horizontal aim is not adjustable. Consult your state
vehicle inspection center for recommended tolerance ranges for visual
aiming.
NOTE:
Before starting fog lamp adjustment, entry conditions must be met.
Vehicle must be on level ground...
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
Scraper for Straight Edges
Hot Air Gun
Knife
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B
-
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information...