Lincoln Aviator: Rear Climate Control / Removal and Installation - Rear Heater Core Outlet Line
Removal
NOTE:
The rear heater core outline is installed from the factory
as a one-piece assembly. The replacement part is supplied as an
assembly, containing the rear heater core inlet line and the rear
evaporator inlet and outlet lines.
-
Remove the rear evaporator rear outlet and inlet line.
Refer to: Rear Evaporator Rear Outlet and Inlet Line (412-02A Rear Climate Control, Removal and Installation).
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
The rear heater core inlet line is installed from the
factory as a one-piece assembly. The replacement part is supplied as an
assembly, containing the rear heater core outlet line and the rear
evaporator inlet and outlet lines...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
Hose Clamp(s)
Hose Clamp Remover/Installer
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Drain the cooling system.
Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03A Engine Cooling - 3...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Using a non-marring tool release and position the light sensor.
Disconnect the electrical connector and remove the light sensor...