Lincoln Aviator: Seatbelts / Seatbelt Extensions
WARNING: Persons who fit into the
vehicle's seatbelt should not use an
extension. Unnecessary use could result
in serious personal injury in the event of a
crash.
WARNING: Only use extensions
provided free of charge by our dealers.
The dealer will provide an extension
designed specifically for this vehicle, model
year and seating position. The use of an
extension intended for another vehicle,
model year or seating position may not
offer you the full protection of your
vehicle's seatbelt restraint system.
WARNING: Never use seatbelt
extensions to install child restraints.
WARNING: Do not use a seatbelt
extension with an inflatable seatbelt.
WARNING: Do not use extensions
to change the way the seatbelt fits across
the torso, over the lap or to make the
seatbelt buckle easier to reach.
If, because of body size or driving position,
it is not possible to properly fasten the
seatbelt over your lap and shoulder, an
extension that is compatible with the
seatbelts is available free of charge from our
dealers. Only use our seatbelt extensions
made by the original equipment seatbelt
manufacturer with our seatbelts. Ask your
authorized dealer if your extension is
compatible with your vehicle restraint system.
Inspect the vehicle seatbelts and child safety
seat systems periodically to make sure they
work properly and are not damaged. Inspect
the vehicle and child restraint seatbelts to
make sure there are no nicks, tears or cuts...
This system provides an improved overall
level of frontal crash protection to front seat
occupants and is designed to help further
reduce the risk of airbag-related injuries...
Other information:
System Diagram
Item
Description
1
SOBDMC/ISC (Inverter System Controller)
2
APIM
3
FCIM
4
BCM
5
BMS
6
DCDC
7
PCM
8
GWM
9
BECM
10
SOBDM/BCCM (Battery Charger Control Module)
11
EVSE (Electric Vehicle Supply Equipment)
12
High Voltage Battery
13
High Voltage Battery Junction Box
14
CSI (Charge Status Indicator)
System Operation
Network Message Chart — SOBDM
Broadcast Message
Originating Module
Message Purpose
High voltage battery state of charge (SOC)
BECM
Used to notify other vehicle modules that the high voltage battery has reached 100% SOC
High voltage battery charge status (not
ready, charge wait, ready, charging, charge complete, fault)
BECM
Used to transition the charger between charging and ready states
Vehicle operating mode
Inverter System Controller (ISC)
Vehicle must be in non-torque producing mode prior to charging
Low voltage support
PCM
Used to activate the low voltage output and support the low voltage system
Gear lever position
PCM
Used to determine transaxle gear state
Ambient air temperature
PCM
Ambient air temperature used for cooling strategy
Maximum current request
BECM
Used to limit and set target setpoint of charger
Maximum voltage request
BECM
Used to limit and set target setpoint of charger
Charge contactor open/close
BECM
High voltage battery charge contactor command
12V battery charge setpoint command
PCM
This message is used to set the 12V battery charging voltage...
Removal
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation).
Release the tab, disconnect the electrical connector and remove the voice microphone.
Installation
To install, reverse the removal procedure...