Lincoln Aviator: Seats / Ventilated Seats
Do not do the following:
- Spill liquid on the front seats. This may cause the air vent holes to become blocked and not work properly.
- Place cargo or objects under the seats. They may block the air intake causing the air vents to not work properly.
The engine must be running to use this feature.
Press this symbol to cycle through the various ventilation settings and off. More indicator lights indicate higher fan speeds.
Note: The ventilated seats switch on during a remote start if they are enabled.
Note: The ventilated seats may switch on when you start your vehicle if they were on when you previously switched your vehicle off.
If the engine falls below 350 RPM when the ventilated seats are on, the system turns off. You need to switch it back on.
Note: To improve comfort, use the ventilated seats along with the vehicle’s air conditioning system.
Automatic Climate Controlled Seats (If Equipped)
When you switch on the auto setting, the seats switch between the heated seats and ventilated seats to match your climate control setting.
Heated Seats
WARNING: Use caution when using
the heated seat if you are unable to feel
pain to your skin because of advanced
age, chronic illness, diabetes, spinal cord
injury, medication, alcohol use, exhaustion
or other physical conditions...
Rear Occupant Alert System
What is the Rear Occupant Alert System
The rear occupant alert system monitors
vehicle conditions and notifies you to check
for rear seat occupants when you switch the
ignition off...
Other information:
Lincoln Aviator 2020-2026 Service Manual: Diagnosis and Testing - Perimeter Anti-Theft Alarm
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Diagnostic Trouble Code Chart Module DTC Description Action BCM B109F:01 Intrusion Sensor Module: General Electrical Failure GO to Pinpoint Test B BCM B109F:02 Intrusion Sensor Module: General Signal Failure GO to Pinpoint Test B BCM B109F:08 Intrusion Sensor Module: Bus Signal / Message Failure GO to Pinpoint Test B BCM B109F:49 Intrusion Sensor Module: Internal Electric Failure GO to Pinpoint Test E BCM B109F:55 Intrusion Sensor Module: Not Configured GO to Pinpoint Test F BCM B109F:97 Intrusion Sensor Module: Component or System Operation Obstructed or Blocked GO to Pinpoint Test B BCM B109F:9A Intrusion Sensor Module: Component or System Operating Conditions GO to Pinpoint Test B BCM B1305:01 Hood Switch: General Electrical Failure GO to Pinpoint Test D BCM B1305:11 Hood Switch: Circuit Short To Ground GO to Pinpoint Test D BCM B1305:15 Hood Switch: Circuit Short To Battery or Open GO to Pinpoint Test D Symptom Chart Symptom Chart: Anti-Theft - Perimeter Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Lincoln Aviator 2020-2026 Service Manual: Description and Operation - Climate Control System Health and Safety Precautions
WARNING: Air conditioning liquid refrigerant R-134a and R-1234yf are capable of harming eyes or freezing skin. Always wear safety goggles and avoid contact with liquid refrigerant. Failure to follow these instructions may result in serious personal injury...
Categories
- Manuals Home
- Lincoln Aviator Owners Manual
- Lincoln Aviator Service Manual
- Remove and Reinstall the Battery
- General Procedures - Transmission Fluid Drain and Refill
- Child Safety Locks
- New on site
- Most important about car
Activating Intelligent Access
The intelligent access key must be within 3 ft (1 m) of the door or luggage compartment you intend to lock or unlock.
At a Door
Electronic door handles are on each door. Gently depress the switch inside the exterior door handle to unlock and open the door. An unlock symbol illuminates on the door window trim indicating your vehicle is unlocked.
