Lincoln Aviator: Battery and Charging System / Accessory Charging
Removal
WARNING:
Disconnect the 12 volt battery before servicing the direct
current to alternating current (DC-AC) inverter or alternating current
(AC) powerpoint to prevent the risk of high voltage shock...
The WACM
is a 5 watt wireless power transmitter designed to energize a secondary
coil found in a secondary device such as a smartphone or in an added
accessory such as a wireless charging phone sleeve...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B10C7:01
Interior Trunk Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B10C9:01
Interior Front Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B10D7:05
PATS Key: System Programming Faliure:
GO to Pinpoint Test C
BCM
B10D7:55
PATS Key: Not Configured:
GO to Pinpoint Test D
BCM
B10D8:00
PATS Key Less Than Minimum Programmed: No Sub Type Information:
GO to Pinpoint Test E
BCM
B10DA:51
PATS Target Identifier: Not Programmed:
GO to Pinpoint Test F
BCM
B1336:01
Left Front Door External Antenna: General Electrical Failure
GO to Pinpoint Test A
BCM
B1337:01
Right Front Door External Antenna: General Electrical Failure
GO to Pinpoint Test A
PCM
P161A:00
Incorrect Response from Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
PCM
P161B:00
Incorrect Response from Secondary Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
SOBDMC
P161A:00
Incorrect Response from Immobilizer Control Module:General Electrical Failure
GO to Pinpoint Test G
Symptom Chart
Symptom Chart: PATS
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
The crankshaft connecting rod journals must be
within specifications to check the connecting rod bearing journal
clearance.
Remove the connecting rod bearing cap and connecting rod bearing...