Lincoln Aviator: General Information / Description and Operation - Climate Control System Health and Safety Precautions
WARNING:
Air conditioning liquid refrigerant R-134a and R-1234yf are
capable of harming eyes or freezing skin. Always wear safety goggles and
avoid contact with liquid refrigerant. Failure to follow these
instructions may result in serious personal injury.
WARNING:
Air conditioning refrigerant R-134a and R-1234yf gases are
capable of displacing the air necessary for breathing in a confined
space and can produce toxic gasses if burned at high temperatures. Do
not release a large quantity of R-134a or R-1234yf gas within a
confined space or allow it to be exposed to a high temperature flame
(such as a torch). Consult the Material Safety Data Sheet (MSDS) for
further information. Failure to follow these instructions may result in
serious personal injury or death.
WARNING:
Use extreme care and observe all safety and service precautions
related to the use of refrigerants as outlined on refrigerant tank and
on recovery and charging equipment. Failure to follow these instructions
may result in serious personal injury.
WARNING:
Before disconnecting any heater water hoses, shut OFF the engine
and wait until engine is fully cool. Failure to comply with this
warning may result in serious injury or burns from hot liquid escaping
from the engine cooling system.
WARNING:
The electric booster heater may become hot during use and can
burn unprotected skin. Allow enough time for the heater to cool before
servicing. Failure to follow this instruction may result in serious
personal injury.
WARNING:
Do not use any fluid other than clean brake fluid meeting
manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained...
This
document provides critical diagnostic knowledge required for successful
repair outcomes. It identifies technical competencies expected by users
of this manual...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
GSM
P0562:00
System Voltage Low: No Sub Type Information
GO to Pinpoint Test B
GSM
P0563:00
System Voltage High: No Sub Type Information
GO to Pinpoint Test C
GSM
P0605:00
Internal Control Module Read Only Memory (ROM) Error: No Sub Type Information
GO to Pinpoint Test L
GSM
P0606:00
Control Module Processor: No Sub Type Information
GO to Pinpoint Test L
GSM
P0607:00
Control Module Performance: No Sub Type Information
GO to Pinpoint Test L
GSM
P06B8:00
Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error: No Sub Type Information
GO to Pinpoint Test L
GSM
P07EC:00
Transmission Range Multi-Function Select Circuit: No Sub Type Information
GO to Pinpoint Test J
GSM
P07ED:00
Transmission Range Multi-Function Select Circuit Stuck: No Sub Type Information
GO to Pinpoint Test J
GSM
P0814:00
Transmission Range Display Circuit: No Sub Type Information
GO to Pinpoint Test I
GSM
P164E:00
Internal Control Module Transmission Range Select Performance: No Sub Type Information
GO to Pinpoint Test L
GSM
P166B:00
Drivers Door Status Correlation: No Sub Type Information
GO to Pinpoint Test H
GSM
U0100:00
Lost Communication With ECM/PCM "A": No Sub Type Information
GO to Pinpoint Test G
GSM
U0100:87
Lost Communication With ECM/PCM "A": Missing Message
GO to Pinpoint Test G
GSM
U0121:00
Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information
GO to Pinpoint Test F
GSM
U0140:00
Lost Communication With Body Control Module: No Sub Type Information
GO to Pinpoint Test E
GSM
U0155:00
Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information
GO to Pinpoint Test D
GSM
U0203:00
Lost Communication With Door Control Module "E": No Sub Type Information
GO to Pinpoint Test H
GSM
U0301:00
Software Incompatibility with ECM/PCM: No Sub Type Available
GO to Pinpoint Test M
GSM
U0401:00
Invalid Data Received from ECM/PCM A: No Sub Type Information
GO to Pinpoint Test N
GSM
U0422:00
Invalid Data Received From Body Control Module: No Sub Type Information
GO to Pinpoint Test N
GSM
U0504:00
Invalid Data Received From Door Control Module "E": No Sub Type Information
GO to Pinpoint Test H
GSM
U1011:00
Invalid Internal Control Module Monitoring Data Received from ECM/PCM: No Sub Type Information
GO to Pinpoint Test O
GSM
U101F:00
Invalid Internal Control Module Monitoring Data Received from ECM/PCM: No Sub Type Information
GO to Pinpoint Test O
Global Customer Symptom Code (GCSC) Chart
Global Customer Symptom Code Chart
Customer Symptom
Action
Start/Run/Move > Moving > Paddle Shift > Inoperative
GO to Pinpoint Test K
Start/Run/Move > Moving > Gear Selector > Return to Park
GO to Pinpoint Test Q
Start/Run/Move > Moving > Gear Selector > Return to Park
GO to Pinpoint Test R
Start/Run/Move > Moving > Engagement Quality > Park
GO to Pinpoint Test P
Start/Run/Move > Moving > Engagement Quality > Park
GO to Pinpoint Test S
Start/Run/Move > Moving > Gear Selector > Progressive Range Selection
GO to Pinpoint Test A
Pinpoint Tests
PINPOINT TEST A : PROGRESSIVE RANGE SELECTION DOES NOT OPERATE CORRECTLY
Refer to Wiring Diagrams Cell 30 for schematic and connector information...
Note: In order to use the Backup Start
Passcode feature, Phone as a Key must be
active and enabled on at least one phone.
If you are unable to start your vehicle, do the
following:
Fully depress the brake pedal.
SYNC displays the Backup Starting
Passcode entry screen...