Lincoln Aviator: Service Information / General Information
Introduction
WARNING:
Before beginning any service procedure in this manual, refer
to health and safety warnings in section 100-00 General Information...
Other information:
The body consists of the following:
Front bumper constructed of high-strength aluminum
Rear bumper constructed of Boron and HSLA ultra high-strength steels
Front frame rails constructed of high-strength aluminum
Rear frame rails constructed of Boron ultra high-strength steel
Fender reinforcement tube constructed of Dual Phase (DP) 800 high-strength steel
Cast aluminum fender apron assembly
Liftgate outer panel constructed of mild steel
Body structure constructed of Boron, Dual Phase (DP) and high-strength steels
Roof panel reinforcements constructed of Dual Phase (DP) 600 and mild steel
Bolted, removable front fenders, hinged doors and hood
Bodyside outer panels constructed of mild steel
Steel hood hinges
Mastic pads used on floor pan for sound deadening
Front End Panel Margining
NOTE:
Margining specifications apply to left hand (LH) and right hand (RH) side of the vehicle unless stated...
Special Tool(s) /
General Equipment
Air Conditioning Service Unit
Refrigerant Identification Equipment
Recovery
NOTICE:
Use an A/C refrigerant analyzer before recovering any of the vehicle's A/C refrigerant. Failure to do so puts the shop's bulk refrigerant at risk of contamination...