Lincoln Aviator: Handles, Locks, Latches and Entry Systems / General Procedures - Staged Unlock Programming
Activation
-
With the ignition in OFF, press the LOCK and UNLOCK buttons on the RKE transmitter simultaneously for 4 seconds.
-
The turn signals flash twice to indicate the mode change.
-
Repeat these steps to enable/disable the staged unlocking feature.
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Interior Trim Remover
Activation
Remove the liftgate latch access cover from the center of the liftgate trim panel...
Removal
Remove the pin-type retainers and the radiator sight shield.
Remove the approach detection antenna.
Disconnect the approach detection antenna electrical connector...
Other information:
Special Tool(s) /
General Equipment
Refrigerant Identification Equipment
Activation
NOTE:
Use Refrigerant Identification Equipment to identify
gas samples taken directly from the refrigeration system or storage
containers prior to recovering or charging the refrigerant system...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Touchscreen controls shown, analog controls are similar.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...