Lincoln Aviator: Electrical / Lighting

Removal and Installation - Voice Microphone

Removal Lower the headliner. Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation). Release the tab, disconnect the electrical connector and remove the voice microphone...

Exterior Lighting

..

Other information:

Lincoln Aviator 2020-2025 Service Manual: Removal and Installation - Reversing Lamp

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Disconnect the reversing lamp assembly camera washer fluid hose and connectors...

Lincoln Aviator 2020-2025 Service Manual: Diagnosis and Testing - Charging System

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   Diagnostic Trouble Code Chart Module   DTC Description Action   BCM B11DB:02 Battery Monitoring Module "A": General Signal Failure   GO to Pinpoint Test F   BCM B11DB:08 Battery Monitoring Module "A": Bus Signal/Message Failures   GO to Pinpoint Test F   BCM B11DB:09 Battery Monitoring Module "A": Component Failures   GO to Pinpoint Test F   BCM B11DB:11 Battery Monitoring Module "A": Circuit Short To Ground   GO to Pinpoint Test F   BCM B11DB:49 Battery Monitoring Module "A": Internal Electronic Failure   GO to Pinpoint Test I   BCM B11DB:55 Battery Monitoring Module "A": Not Configured   GO to Pinpoint Test J   BCM B1489:11 Battery Monitoring System (BMS) Sensor Power: Circuit Short To Ground   GO to Pinpoint Test F   PCM P0562:00 System Voltage Low: No Sub Type Information   GO to Pinpoint Test B   PCM P0563:00 System Voltage High: No Sub Type Information   GO to Pinpoint Test A   PCM P065B:00 Generator "A" Control Circuit Range/Performance: No Sub Type Information   GO to Pinpoint Test B   PCM P065C:00 Generator "A" Mechanical Performance: No Sub Type Information   GO to Pinpoint Test B   PCM P0A3B:00 Generator "A" Over Temperature: No Sub Type Information   GO to Pinpoint Test K   PCM P0A5A:00 Generator Current Sensor Circuit Range/Performance: No Sub Type Information   GO to Pinpoint Test E   PCM P0A5B:00 Generator Current Sensor Circuit Low: No Sub Type Information   GO to Pinpoint Test E   PCM P0A5C:00 Generator Current Sensor Circuit High: No Sub Type Information   GO to Pinpoint Test E   PCM U012D:00 Lost Communication With Generator "A" Control Module: No Sub Type Information   GO to Pinpoint Test G   PCM U042E:00 Invalid Data Received From Generator "A" Control Module: No Sub Type Information   GO to Pinpoint Test G Inspection and Verification Verify the customer concern by operating the charging system...