Lincoln Aviator: Climate Control System - General Information / Removal and Installation - Air Conditioning (A/C) Pressure Transducer - 3.0L EcoBoost
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Disconnect the electrical connector and remove the A/C pressure transducer.
Installation
-
To install, reverse the removal procedure.
Removal
NOTICE:
During the removal of components, cap, tape or otherwise
appropriately protect all openings to prevent the ingress of dirt or
other contamination...
Removal
Fully lower the glove compartment.
Disconnect the check strap.
Push the stop tabs inward.
Remove the screws and the air distribution door actuator...
Other information:
Special Tool(s) /
General Equipment
303-050
(T70P-6000)
Lifting Bracket, Engine
303-F070Support Bar, EngineTKIT-1999A-F/LTTKIT-1999A-FM/FLM
Removal
NOTE:
AWD shown, RWD similar.
With the vehicle in NEUTRAL, position it on a hoist...
Programming
This procedure should be performed when a new
transmission or main control valve body is installed in the vehicle.
13 - digit solenoid body strategy
12 - digit solenoid body identification
If a new main control was installed, record the
13-digit solenoid body strategy from the replacement solenoid body tag
provided with the main control service kit...