Lincoln Aviator: Scheduled Maintenance

Lincoln Protect

PROTECT YOURSELF FROM THE RISING COST OF VEHICLE REPAIRS WITH LINCOLN PROTECT EXTENDED SERVICE PLAN. Lincoln Protect Extended Service Plans (U.S. Only) Lincoln Protect means peace of mind...

General Maintenance Information

..

Other information:

Lincoln Aviator 2020-2026 Service Manual: Description and Operation - Climate Control System - System Operation and Component Description

System Operation System Diagram Item Description 1 FDIM 2 Microphone 3 APIM 4 GWM 5 Ambient Air Temperature (AAT) sensor 6 PCM 7 A/C pressure transducer 8 A/C clutch relay ( BCMC) 9 A/C compressor clutch field coil 10 Externally Controlled Variable Displacement Compressor (EVDC) 11 Sunload sensor 12 In-vehicle temperature and humidity sensor 13 Evaporator temperature sensor 14 HVAC control module 15 Air distribution door actuator 16 Temperature door actuator 17 Passenger side temperature door actuator 18 Air inlet door actuator 19 Blower motor relay (BCMC) 20 Blower motor control module 21 Driver side register air discharge temperature sensor 22 Passenger side register air discharge temperature sensor 23 Driver side footwell air discharge temperature sensor 24 Ambient air quality sensor (if equipped) 25 Passenger side footwell air discharge temperature sensor 26 SOBDMC 27 ACCM 28 BCM 29 Particulate filter sensor (if equipped) Network Message Chart   ACCM - Module Network Input Messages Broadcast Message Originating Module Message Purpose Ambient air temperature filtered PCM \ PCM_ HEV This message contains the climate control system controls ambient air temperature information...

Lincoln Aviator 2020-2026 Service Manual: Removal and Installation - Rear Door Upper Moulding

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the upper belt moulding screw at front of the door. Torque: 12 lb.in (1.3 Nm) Lift the moulding at the front edge using a non-marring trim tool and slide forward to disengage from the tab at the rear and remove the moulding...