Lincoln Aviator: Suspension / Wheels and Tires
Special Tool(s) /
General Equipment
Hydraulic Press
Removal
Remove the wheel bearing and wheel hub.
Refer to: Wheel Bearing and Wheel Hub (204-02 Rear Suspension, Removal and Installation)...
Material
Item
Specification
Fill Capacity
Motorcraft® High Temperature Nickel Anti-Seize Lubricant
XL-2
-
Motorcraft® Wheel and Tire Cleaner
ZC-37-A
-
General Specifications
Item
Specification
Tire Inflation
Tires
See Safety Certification Label on driver door jamb
Wheel Weights
Wheel weight type
Use a wheel weight manufacturer's rim gauge to determine the correct wheel weight application
Torque Specifications
Item
Nm
lb-ft
lb-in
Valve stem-to-TPMS sensor screw...
Other information:
The body consists of the following:
Front bumper constructed of high-strength aluminum
Rear bumper constructed of Boron and HSLA ultra high-strength steels
Front frame rails constructed of high-strength aluminum
Rear frame rails constructed of Boron ultra high-strength steel
Fender reinforcement tube constructed of Dual Phase (DP) 800 high-strength steel
Cast aluminum fender apron assembly
Liftgate outer panel constructed of mild steel
Body structure constructed of Boron, Dual Phase (DP) and high-strength steels
Roof panel reinforcements constructed of Dual Phase (DP) 600 and mild steel
Bolted, removable front fenders, hinged doors and hood
Bodyside outer panels constructed of mild steel
Steel hood hinges
Mastic pads used on floor pan for sound deadening
Front End Panel Margining
NOTE:
Margining specifications apply to left hand (LH) and right hand (RH) side of the vehicle unless stated...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the fuel pump sender unit.
Refer to: Fuel Pump and Sender Unit (310-01A Fuel Tank and Lines - 3.0L EcoBoost, Removal and Installation).
Disconnect the electrical connector...