Lincoln Aviator: Remote Convenience / Diagnosis and Testing - Universal Transmitter
Symptom Chart(s)
Symptom Chart: Universal Home Transmitter
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Symptom Chart
Condition
|
Actions
|
The universal transmitter is inoperative
|
GO to Pinpoint Test A
|
Pinpoint Tests
.jpg)
PINPOINT TEST A : UNIVERSAL TRANSMITTER IS INOPERATIVE
Normal Operation and Fault Conditions
REFER to: Universal Transmitter - Overview (419-02 Remote Convenience, Description and Operation).
Possible Sources
- Interior lighting concern
- Universal transmitter (part of the LH sun visor)
|
A1 CHECK FOR VOLTAGE TO THE UNIVERSAL TRANSMITTER |
-
Check the illumination of the universal transmitter by pressing one of the buttons.
Does the indicator on the universal transmitter illuminate?
|
A2 PROGRAM A HAND-HELD TRANSMITTER TO THE UNIVERSAL TRANSMITTER |
-
NOTE:
The customer's hand-held transmitter is required when programming the universal transmitter.
Program the universal transmitter. Refer to the Owner's Literature.
Does the universal transmitter program successfully?
Yes |
The universal transmitter is OK. VERIFY the receiver unit operates correctly.
|
No |
INSTALL a new LH sun visor.
|
|
A3 CHECK THE OPERATION OF THE LH (LEFT-HAND)
VANITY MIRROR LAMP |
-
Verify the operation of the LH vanity mirror lamp.
REFER to: Interior Lighting (417-02 Interior Lighting, Diagnosis and Testing).
Does the LH vanity mirror lamp operate correctly?
Yes |
INSTALL a new LH sun visor.
|
No |
Diagnose the interior lighting concern. REFER to: Interior Lighting (417-02 Interior Lighting, Diagnosis and Testing).
|
|
System Operation
Universal Transmitter
The universal transmitter learns a hand-held transmitter radio
frequency code and stores the code in memory...
Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Cleaning
Clean the exhaust manifold using a suitable solvent. Use
a plastic scraping tool to clean the gasket sealing surfaces.
Inspection
NOTE:
New exhaust manifold gaskets, studs, nuts and/or
bolts must be installed when an exhaust manifold is serviced...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the upper belt moulding screw at front of the door.
Torque:
12 lb.in (1.3 Nm)
Lift the moulding at the front edge using a non-marring
trim tool and slide forward to disengage from the tab at the rear and
remove the moulding...