Lincoln Aviator: Automatic Transmission / Transmission Cooling - 10-Speed Automatic Transmission – 10R60
Special Tool(s) /
General Equipment
204-594Forcing screw
307-549Installer, Shift Shaft Fluid SealTKIT-2005D1-F1
307-648Remover/Installer, Rear BearingTKIT-2009C-FTKIT-2009C-ROW
307-745Installer, Park Sleeve Roll Pin
307-781Needle bearing remover/Installer
307-788Installer, sleeve
307-789Installer, sleeve
NOTE:
This step is only necessary if the transmission case is
being replaced...
The
transmission fluid cooling system consists of a heat exchanger mounted
to the transmission. The heat exchanger has both transmission fluid and
engine coolant flowing through it in separate chambers...
Other information:
Note: Each road tire is equipped with a tire
pressure sensor located inside the wheel
and tire assembly cavity. The pressure
sensor is attached to the valve stem. The
pressure sensor is covered by the tire and
is not visible unless the tire is removed...
Repair
NOTE:
This procedure may be carried out on rubber hoses only. If a
plastic washer hose is damaged, a new washer hose must be installed.
Locate and verify the damaged washer hose.
Cut the hose cleanly and remove the damaged portion of the washer hose...