Lincoln Aviator: Front Seats / Removal and Installation - Front Seat Track
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front seat backrest.
Refer to: Front Seat Backrest (501-10A Front Seats, Removal and Installation).
-
Remove the front seatbelt buckle.
Refer to: Front Seatbelt Buckle (501-20A Seatbelt Systems, Removal and Installation).
-
Remove the front seat cushion extension adjuster.
Refer to: Front Seat Cushion Extension Adjuster (501-10A Front Seats, Removal and Installation).
-
Remove the seat position sensor.
Refer to: Seat Position Sensor (501-20B)
.
Installation
All seats
-
NOTE:
Transfer components to the new front seat track as necessary.
To install, reverse the removal procedure.
Seats with memory
-
NOTE:
This step is only necessary when installing a new component.
Operate the seat in all directions through the full
range of travel to set soft stops on all memory controlled functions and
avoid a premature stopping point occurrence after the vehicle is
returned to the customer.
Removal
NOTE:
Driver seat shown, passenger seat similar.
Power lumbar assembly
Remove the SCMG.
Refer to: Driver Multi-Contour Seat Module [SCMG] (501-10A Front Seats, Removal and Installation)...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTICE:
Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE:
Removal steps in this procedure may contain installation details...
Roof Opening Panel
The roof opening panel consists of the following:
Air deflector
Sliding glass panel
Sliding glass panel motor
Shield assembly
Shield motor
Roof opening panel fixed glass
Roof opening panel frame assembly
Roof opening panel drain hoses
Roof opening panel control switch
Roof opening panel seal
The
roof opening panel motor must be initialized when repairs are carried
out on the roof opening panel system, including: any time the roof
opening panel motor has been removed, the roof opening panel glass
(sliding or fixed glass) has been removed or adjusted, or if the roof
opening panel frame has been removed...