Lincoln Aviator: SYNC™ 3 / Electric Vehicle Information
HERE is the digital map provider for the
navigation application. If you find map data
errors, you may report them directly to HERE
by going to www.here...
Power Flow
The Power Flow information for
your plug-in hybrid vehicle is
available through the Home screen
or under Apps.
Vehicle Operational States
Power will flow to or from the front and rear
wheels depending on operational state and
drive conditions...
Other information:
System Diagram
Item
Description
1
SOBDMC/ISC (Inverter System Controller)
2
APIM
3
FCIM
4
BCM
5
BMS
6
DCDC
7
PCM
8
GWM
9
BECM
10
SOBDM/BCCM (Battery Charger Control Module)
11
EVSE (Electric Vehicle Supply Equipment)
12
High Voltage Battery
13
High Voltage Battery Junction Box
14
CSI (Charge Status Indicator)
System Operation
Network Message Chart — SOBDM
Broadcast Message
Originating Module
Message Purpose
High voltage battery state of charge (SOC)
BECM
Used to notify other vehicle modules that the high voltage battery has reached 100% SOC
High voltage battery charge status (not
ready, charge wait, ready, charging, charge complete, fault)
BECM
Used to transition the charger between charging and ready states
Vehicle operating mode
Inverter System Controller (ISC)
Vehicle must be in non-torque producing mode prior to charging
Low voltage support
PCM
Used to activate the low voltage output and support the low voltage system
Gear lever position
PCM
Used to determine transaxle gear state
Ambient air temperature
PCM
Ambient air temperature used for cooling strategy
Maximum current request
BECM
Used to limit and set target setpoint of charger
Maximum voltage request
BECM
Used to limit and set target setpoint of charger
Charge contactor open/close
BECM
High voltage battery charge contactor command
12V battery charge setpoint command
PCM
This message is used to set the 12V battery charging voltage...
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
The crankshaft connecting rod journals must be
within specifications to check the connecting rod bearing journal
clearance.
Remove the connecting rod bearing cap and connecting rod bearing...