Lincoln Aviator: Suspension / Rear Suspension
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
DISASSEMBLY
WARNING:
Vent all air pressure from the air suspension system prior
to disconnecting or removing any air suspension components...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCMC
U0100:87
Lost Communication With ECM/PCM "A": Missing Message
GO to Pinpoint Test A
BCMC
U0111:87
Lost Communication With Battery Energy Control Module "A": Missing Message
GO to Pinpoint Test B
BCMC
U0140:87
Lost Communication With Body Control Module: Missing Message
GO to Pinpoint Test C
BCMC
U0164:87
Lost Communication With HVAC Control Module: Missing Message
GO to Pinpoint Test D
BCMC
U024D:87
Lost Communication With "Seat Control Module J": Missing Message
GO to Pinpoint Test E
BCMC
U0293:87
Lost Communication With Hybrid/EV Powertrain Control Module: Missing Message
GO to Pinpoint Test F
BCMC
U1000:00
Solid State Driver Protection Active: Driver Disabled: No Sub Type Information
GO to Pinpoint Test G
BCMC
U2100:00
Initial Configuration Not Complete: No Sub Type Information
GO to Pinpoint Test H
BCMC
U2200:00
Control Module Configuration Memory Corrupt: No Sub Type Information
GO to Pinpoint Test H
BCMC
U3000:49
Control Module: Internal Electronic Failure
GO to Pinpoint Test I
BCMC
U3003:16
Battery Voltage: Circuit Voltage Below Threshold
GO to Pinpoint Test J
BCMC
U3003:17
Battery Voltage: Circuit Voltage Above Threshold
GO to Pinpoint Test K
Pinpoint Tests
PINPOINT TEST A : U0100:87
Refer to Wiring Diagrams Cell 14 for schematic and connector information...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Detach the clips and lower the LH lower steering column trim panel.
Disconnect the headlamp switch electrical connector.
Release the tabs and remove the headlamp switch...