Lincoln Aviator: Engine / Engine - 3.0L EcoBoost
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
Measure the diameter of each intake and exhaust valve
stem at the points shown...
Engine
Item
Specification
Displacement
2.956L (4V) (164 CID)
No. of cylinders
6
Bore/stroke
85...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCM
B130F:12
Run Accessory Control: Circuit Short To Battery
GO to Pinpoint Test A
BCM
B130F:14
Run Accessory Control: Circuit Short To Ground or Open
GO to Pinpoint Test A
BCM
B130F:14
Run Accessory Control: Circuit Short To Ground or Open
GO to Pinpoint Test D
SCCM
B10AD:02
Rain Sensor: General Signal Failure
GO to Pinpoint Test F
SCCM
B10AD:08
Rain Sensor: Bus Signal / Message Failure
GO to Pinpoint Test F
SCCM
B10AD:49
Rain Sensor:Internal Electronic Failure
GO to Pinpoint Test Q
SCCM
B10AD:55
:Rain Sensor:Not Configured
GO to Pinpoint Test P
SCCM
B1131:02
Wiper motor module: General Signal Failure
GO to Pinpoint Test A
SCCM
B1131:02
Wiper Motor Module: General Signal Failure
GO to Pinpoint Test D
SCCM
B1131:08
Wiper motor module: Bus Signal / Message Failure
GO to Pinpoint Test B
SCCM
B1131:11
Wiper motor module: Circuit Short to Ground
GO to Pinpoint Test B
SCCM
B1131:49
Wiper Motor Module:Internal Electronic Failure
GO to Pinpoint Test R
SCCM
B1131:55
:Wiper Motor Module: Not Configured
GO to Pinpoint Test P
SCCM
B124E:11
Wiper Stalk Switch Pack: Circuit Short To Ground
GO to Pinpoint Test V
SCCM
B124E:13
Wiper Stalk Switch Pack: Circuit Open
GO to Pinpoint Test V
SCCM
B124E:55
Wiper Stalk Switch: Not Configured
GO to Pinpoint Test V
SCCM
B124E:96
Wiper Stalk Switch Pack: Component Internal Failure
GO to Pinpoint Test V
SCCM
B124E:9E
Wiper Stalk Switch Pack: Stuck On
GO to Pinpoint Test V
Symptom Chart
Symptom Chart: Wiper and Washer
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
The cruise controls are on the steering
wheel.
Switching Adaptive Cruise Control On
Press the button to set the
system
in standby mode.
The indicator, current gap setting and set
speed appear in the information display.
Switching Adaptive Cruise Control Off
Press the button when the system
is in standby mode, or switch the
ignition off...