Lincoln Aviator: Brake System / Rear Disc Brake
Removal
WARNING:
Service actions on vehicles equipped with electronic brake
booster and electronic parking brakes may cause unexpected brake
application, which could result in injury to hands or fingers...
Other information:
DTC Chart: DDM
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
DTC
Description
Action
B11F6:11
Driver Folding Mirror Motor: Circuit Short To Ground
GO to Pinpoint Test E
B11F6:15
Driver Folding Mirror Motor: Circuit Short To Battery or Open
GO to Pinpoint Test E
B1163:11
Left Mirror Heater Output: Circuit Short To Ground
GO to Pinpoint Test D
B1163:15
Left Mirror Heater Output: Circuit Short To Battery Or Open
GO to Pinpoint Test D
B1C09:11
Driver Left/Right Mirror Motor: Circuit Short To Ground
GO to Pinpoint Test B
B1C09:15
Driver Left/Right Mirror Motor: Circuit Short To Battery Or Open
GO to Pinpoint Test B
B1C10:11
Driver Up/Down Mirror Motor: Circuit Short To Ground
GO to Pinpoint Test C
B1C10:15
Driver Up/Down Mirror Motor: Circuit Short To Battery Or Open
GO to Pinpoint Test C
B1C13:11
Driver Up/Down Mirror Motor Feedback: Circuit Short To Ground
GO to Pinpoint Test C
B1C13:15
Driver Up/Down Mirror Motor Feedback: Circuit Short To Battery Or Open
GO to Pinpoint Test C
B1C14:11
Driver Left/Right Mirror Motor Feedback: Circuit Short To Ground
GO to Pinpoint Test C
B1C14:15
Driver Left/Right Mirror Motor Feedback: Circuit Short To Battery Or Open
GO to Pinpoint Test C
C1B15:11
Sensor Supply Voltage B: Circuit Short To Ground
GO to Pinpoint Test C
C1B15:15
Sensor Supply Voltage B: Circuit Short To Battery or Open
GO to Pinpoint Test C
All other DDM Diagnostic Trouble Codes (DTCs)
-
REFER to: Locks, Latches and Entry Systems (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...