Lincoln Aviator: Suspension / Vehicle Dynamic Suspension

Removal and Installation - Tire Pressure Monitoring System (TPMS) Sensor

Removal   WARNING: The Tire Pressure Monitoring System (TPMS) sensor battery may release hazardous chemicals if exposed to extreme mechanical damage...

Description and Operation - Vehicle Dynamic Suspension - Component Location

..

Other information:

Lincoln Aviator 2020-2026 Service Manual: Diagnosis and Testing - Trailer Lamps

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   Diagnostic Trouble Code Chart Module   DTC Description Action   BCM B1449:12 Trailer Tow Park/Tail Lamp Output: Circuit Short To Battery   GO to Pinpoint Test C   BCM B1449:14 Trailer Tow Park/Tail Lamp Output: Circuit Short To Ground or Open   GO to Pinpoint Test C   TRM B10E8:4B Secondary Battery Relay "A": Over Temperature   GO to Pinpoint Test E   TRM B1D08:11 Left Trailer Direction Indicator: Circuit Short To Ground   GO to Pinpoint Test B   TRM B1D08:12 Left Trailer Direction Indicator: Circuit Short To Battery   GO to Pinpoint Test B   TRM B1D09:11 Right Trailer Direction Indicator: Circuit Short To Ground   GO to Pinpoint Test B   TRM B1D09:12 Right Trailer Direction Indicator: Circuit Short To Battery   GO to Pinpoint Test B   TRM U0140:00 Lost Communication With Body Control Module: No Sub-Type Information   GO to Pinpoint Test F   TRM U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information   GO to Pinpoint Test H   TRM U2100:00 Initial Configuration Not Complete: No Sub Type Information   GO to Pinpoint Test G   TRM U3000:49 Control Module: Internal Electronic Failure   GO to Pinpoint Test H Symptom Charts Symptom Chart: Trailer Lamps Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

Lincoln Aviator 2020-2026 Service Manual: Removal and Installation - Radio Transceiver Module (RTM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation...