Lincoln Aviator: Instrumentation and Warning Systems / Parking Aid - Vehicles With: Parking Aid Camera
Removal
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
If equipped.
Position aside the connector shield...
Other information:
Removal
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the antenna cable connector(s).
Remove the bolt, the bracket and the roof mounted antenna...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCMC
U0100:87
Lost Communication With ECM/PCM "A": Missing Message
GO to Pinpoint Test A
BCMC
U0111:87
Lost Communication With Battery Energy Control Module "A": Missing Message
GO to Pinpoint Test B
BCMC
U0140:87
Lost Communication With Body Control Module: Missing Message
GO to Pinpoint Test C
BCMC
U0164:87
Lost Communication With HVAC Control Module: Missing Message
GO to Pinpoint Test D
BCMC
U024D:87
Lost Communication With "Seat Control Module J": Missing Message
GO to Pinpoint Test E
BCMC
U0293:87
Lost Communication With Hybrid/EV Powertrain Control Module: Missing Message
GO to Pinpoint Test F
BCMC
U1000:00
Solid State Driver Protection Active: Driver Disabled: No Sub Type Information
GO to Pinpoint Test G
BCMC
U2100:00
Initial Configuration Not Complete: No Sub Type Information
GO to Pinpoint Test H
BCMC
U2200:00
Control Module Configuration Memory Corrupt: No Sub Type Information
GO to Pinpoint Test H
BCMC
U3000:49
Control Module: Internal Electronic Failure
GO to Pinpoint Test I
BCMC
U3003:16
Battery Voltage: Circuit Voltage Below Threshold
GO to Pinpoint Test J
BCMC
U3003:17
Battery Voltage: Circuit Voltage Above Threshold
GO to Pinpoint Test K
Pinpoint Tests
PINPOINT TEST A : U0100:87
Refer to Wiring Diagrams Cell 14 for schematic and connector information...